Digital Pressure Sensor
Digital Pressure Sensor
At Mercury Pneumatics , we specialize in integrating cutting-edge digital pressure sensors into pneumatic systems to ensure optimal performance and reliability. Our digital pressure sensors provide accurate, real-time monitoring and control of pneumatic pressures, enhancing the efficiency and safety of your operations. With advanced features such as multiple selection of units, , quick response times, Low and high pressure range monitoring, Digital and Analog outputs as well as variety of mounting options, our sensors are designed to meet the rigorous demands of modern pneumatic applications.
Datasheet 2MB
Catalogue 766 KB
Enquire Now
Digital Pressure Switch
| Technical Specifications | |
|---|---|
| Model No | DPS 3015 |
| Port Size | 1/8″ BSP / Internal thread M5 |
| Rated Pressure Range | -1 ~ 10 bar |
| Operating Pressure Range | -1 ~ 10 bar |
| Maximum Pressure | 15 bar |
| Measurement Modes |
Easy Mode Hysteresis Mode Compare Mode of Upper & Lower Bands |
| Fluid | Air |
| Voltage Range | 12-24VDC ±10% |
| Current Consumption | 40mA max (non-load) |
| Transistor Output |
NPN / PNP open-collector output Output Current: 80mA MAX |
| Response Time | Adjustable : MIN, 2.5mS |
| Analog Output (Voltage) | 1-5V, Load resistance > 1KΩ |
| IP Level | IP40 |
| Ambient Temperature | Operation : 0 ~ 50°C, Storage : -20 ~ 60°C |
| Ambient Humidity Range | Operating humidity 35 ~ 85% RH |
| Insulation Voltage | 1000VAC |
| Insulation Resistance | > 50MΩ, 500VDC |
| Shock | Max 100m/s², 3 times each in direction of X, Y & Z |
| Vibration | Amplitude 1.5mm, 10Hz~500Hz, 2 hours each direction of X, Y & Z |
Frequently Asked Questions (FAQ)
Q: What is the pressure monitoring range of the Mercury Digital Pressure Switch?The standard Mercury DPS3015 series is designed for a pressure range of 1 to 10 bar, with a maximum pressure endurance limit of up to 15 bar.
Q: Are Mercury Digital Pressure Switch provided with an output signal?
Mercury DPS30151 model comes with an analogue output of 0-5V which can be used to give feedback to your PLC
Q: Can the response time of the digital switch be adjusted?
Yes. The response time is user-adjustable, reaching a rapid minimum response speed of 2.5 ms. This enables high-speed signal feedback for rapid-cycle automation.
Q: The pressure readings are fluctuating rapidly on the display. How can I stabilize it?Rapidly fluctuating readings usually indicate air turbulence or rapid pressure pulses in the pneumatic line. You can resolve this by adjusting the sensor’s built-in response time delay setting to dampen out minor line noise, or by checking for leaks near the 1/8″ BSP port.
Q: what types of mountings are available?
Mercury’s DPS series comes with 3 type option of mounting i.e panel mounting, L bracket or S bracket. The suitable mounting option needs to be orders by using the correct suffix on the part number